summaryrefslogtreecommitdiff
Commit message (Expand)AuthorAgeFilesLines
* Cr50: Enable the USB SOF clock auto-calibrationstabilize-8282.BBill Richardson2016-05-044-4/+167
* gru: Initial mainboard commitShawn Nematbakhsh2016-05-048-10/+52
* rk3399: Set power state based on input signalsShawn Nematbakhsh2016-05-044-19/+73
* npcx: add device id for npcx586g/npcx576gKevin K Wong2016-05-041-0/+4
* board: rename it8380dev to it83xx_evbDino Li2016-05-037-1/+1
* apollolake: ignore PLTRST# from SOC unless RSMRST# is deassertedKevin K Wong2016-05-033-4/+25
* Cr50: Enable jittery clockBill Richardson2016-05-035-0/+71
* CR50: fix issue in ecc parameter endian conversionnagendra modadugu2016-05-031-4/+4
* elm: Set USB_DP_HPD as inputNicolas Boichat2016-05-033-81/+2
* CR50: remove checks on RSA key buffer sizenagendra modadugu2016-05-031-5/+0
* Add the lock key to the keyboard mask on kevinDavid Schneider2016-05-021-1/+1
* npcx: Reduce system stack sizeShawn Nematbakhsh2016-05-021-1/+1
* sb_firmware_update: Set ac flag at fw update modeBruce2016-05-021-2/+19
* usb_updater: retransmit upgrade blocks if target does not replyVadim Bendebury2016-05-021-25/+50
* g: enhance upgrade protocol to allow upgrade block restartsVadim Bendebury2016-05-021-3/+38
* g: verify that first message of each upgrade block is rightVadim Bendebury2016-05-021-11/+13
* g: upgrade - improve verification of the first upgrade messageVadim Bendebury2016-05-021-6/+35
* g: introduce versioning and backwards compatibility of usb_upgradeVadim Bendebury2016-05-022-10/+92
* g: drop: always start with USB facing external portVadim Bendebury2016-05-021-3/+8
* usb_updater: shut down on errors more gracefully and simplify APIsVadim Bendebury2016-05-021-55/+53
* g: fix debug messages not to include two newlinesVadim Bendebury2016-05-021-6/+6
* g: recover from usb_upgrade interruptionsVadim Bendebury2016-05-021-1/+27
* kevin: Add support 3 color LEDWonjoon Lee2016-05-015-10/+182
* Invert KSO2 on KevinDavid Schneider2016-04-302-1/+4
* CR50: point multiply should check point for curve membershipnagendra modadugu2016-04-301-1/+3
* cr50: add basic rbox supportMary Ruthven2016-04-298-6/+147
* kevin: Decode board versionShawn Nematbakhsh2016-04-292-0/+46
* kevin: GPIO changes for new proto buildShawn Nematbakhsh2016-04-294-26/+29
* cr50: set SYS_RST_L as an inputMary Ruthven2016-04-291-1/+1
* Cr50: Move board-specific rdd stuff out of chip/g/Bill Richardson2016-04-293-13/+11
* STM32: Add HSE and PLL to clock source selectionDaisuke Nojiri2016-04-294-51/+275
* STM32: Set UART clock sources to SYSCLKDaisuke Nojiri2016-04-292-3/+13
* CR50: remove unused config option CONFIG_RSA, some cleanupnagendra modadugu2016-04-271-4/+3
* Tell git to ignore all private subdirectoriesBill Richardson2016-04-271-2/+1
* chell: Keep KB light PWM active during low-power idleShawn Nematbakhsh2016-04-271-1/+2
* pwm: Add PWM_CONFIG_DSLEEP config flagShawn Nematbakhsh2016-04-2712-28/+60
* servo_v4: add initial servo_v4 buildNick Sanders2016-04-276-0/+441
* fusb302: Delay after enabling CC measurement switchesShawn Nematbakhsh2016-04-271-6/+10
* g: i2c slave driverVadim Bendebury2016-04-272-0/+233
* tpm_regs: clean up debug messagesVadim Bendebury2016-04-271-5/+5
* servo_micro: add gpio mode get and setNick Sanders2016-04-276-13/+163
* checkpatch: do not consider split text strings a problemVadim Bendebury2016-04-271-0/+5
* UART: Remove X-on/X-off flow controlAnton Staaf2016-04-271-50/+10
* UART: Remove enable/disable interrupt functionsAnton Staaf2016-04-279-104/+5
* cr50: enable AP and EC flash accessstabilize-8249.BMary Ruthven2016-04-264-0/+23
* pd: Fix port enable check for low power idleShawn Nematbakhsh2016-04-252-2/+2
* STM32: Support LPUART consoleDaisuke Nojiri2016-04-256-5/+42
* Bring up STM32L476G-EvalDaisuke Nojiri2016-04-2518-16/+508
* STM32: Add dma_select_channelDaisuke Nojiri2016-04-254-0/+38
* snoball: GPIO changes for proto 1Shawn Nematbakhsh2016-04-253-152/+6