summaryrefslogtreecommitdiff
Commit message (Expand)AuthorAgeFilesLines
* ACPI: Support accessing memmap data over ACPI CMD / DATA portsstabilize-6915.BShawn Nematbakhsh2015-03-2513-129/+304
* Ryu: Add support for the SPI over USB bridgeAnton Staaf2015-03-253-14/+69
* charger: bq24773: Fix read input current errorstabilize-6912.Bjames_chao2015-03-241-2/+2
* charger: Add support for bq24770james_chao2015-03-244-27/+109
* CCD: Add ability to enable and disable SPI bridgestabilize-6909.BAnton Staaf2015-03-233-40/+84
* USB-SPI: Set the interface SubClass to Google SPIAnton Staaf2015-03-232-2/+5
* it8380dev: add KBC/KMSC moduleDino Li2015-03-2214-62/+610
* cr50: Added PMU driverSheng-Liang Song2015-03-214-316/+767
* cr50: Added macros for register read/writeSheng-Liang Song2015-03-202-7/+90
* cr50: added cr50 a1 chipSheng-Liang Song2015-03-2013-7/+18598
* spi_flash: Rework protection translation functionsShawn Nematbakhsh2015-03-175-237/+245
* USB: Add udev rule to handle CCD devicesAnton Staaf2015-03-161-0/+14
* lm4: stm32: Store panic data in backup registers on hard resetShawn Nematbakhsh2015-03-148-20/+136
* ectool: Always try v0 of GET_VERSIONS command if v1 failsShawn Nematbakhsh2015-03-141-1/+1
* pd: make source-only PD devices compatible with the common runtimeVincent Palatin2015-03-132-5/+11
* honeybuns: fix CC voltage thresholdsVincent Palatin2015-03-121-4/+4
* honeybuns: fix CC line sensing ADCVincent Palatin2015-03-121-1/+1
* honeybuns: add HX3 hub configurationVincent Palatin2015-03-122-1/+117
* honeybuns: Initial /board filesScott Collyer2015-03-128-0/+728
* mec1322: Add flash physical interface functionsShawn Nematbakhsh2015-03-129-21/+282
* spi_flash: Add protect support for W25X40Shawn Nematbakhsh2015-03-116-20/+117
* Ryu: Share SensorHub UART control with ServoAnton Staaf2015-03-101-1/+3
* llama: enable the EC backlight override for mediatek platform.Ben Lok2015-03-092-2/+35
* llama: implement battery ship shutdown modeyh.huang2015-03-092-1/+40
* usb_pd: fix HPD State error under IRQ_HPDBernard Shyu2015-03-071-1/+1
* samus: ryu: allow charge ramp on CDP and proprietary chargersAlec Berg2015-03-075-8/+27
* lightbar: clear all segments first before starting konami seqAlec Berg2015-03-061-0/+3
* flash_ec: add support for strago and cyanBernie Thompson2015-03-061-0/+2
* mec1322: Remove RO image to save program memoryShawn Nematbakhsh2015-03-061-3/+8
* samus: change tap for battery to not show dimmed last segmentAlec Berg2015-03-062-1/+19
* samus: limit input current when batt near full and 5V chargerAlec Berg2015-03-062-23/+51
* motion_sense: Add required headerAlexandru M Stan2015-03-061-0/+2
* samus_pd: disable i2cxfer console command to save spaceAlec Berg2015-03-063-0/+4
* charge_state_v2: add battfake console commandAlec Berg2015-03-061-0/+32
* pi3usb9281: Always set reserved control bitsShawn Nematbakhsh2015-03-042-10/+14
* Ryu: Add support for AP and SH console forwarding over USBAnton Staaf2015-03-043-12/+95
* USB Stream: Make RX and TX buffer sizes configurableAnton Staaf2015-03-033-8/+38
* sb_firmware: shorter console messagesstabilize-6842.BSheng-Liang Song2015-03-021-3/+1
* nrf51: Reset clean up.Myles Watson2015-03-023-12/+22
* Producer/Consumer: Convert USART and USB Stream driversAnton Staaf2015-03-026-296/+221
* pd: Bugfix for write log entry command.Todd Broch2015-03-021-1/+1
* plankton: always run as UFP when in USB hub modeVic Yang2015-03-023-10/+25
* Revert "mec1322: Fix LPC interrupt bit mask"stabilize-6835.BVic Yang2015-02-281-4/+4
* sb_firmware: clean up sb firmware update programSheng-Liang Song2015-02-281-53/+55
* stm32f0: Fix RTC read glitchShawn Nematbakhsh2015-02-281-1/+7
* samus: don't unwedge charging when purposely discharging on ACAlec Berg2015-02-283-3/+23
* nrf51: add RNG definitions to registers.hMyles Watson2015-02-281-0/+21
* nrf51: add definitions for RADIO and FICR registers.Myles Watson2015-02-281-0/+183
* charge_state_v2: return correct host command error codesAlec Berg2015-02-281-2/+2
* Remove unused CONFIG_PSTATE_AT_END optionRandall Spangler2015-02-274-41/+3