summaryrefslogtreecommitdiff
Commit message (Expand)AuthorAgeFilesLines
* flash_fp_mcu: Add config zork, uart transport and gpiosstabilize-quickfix-13421.74.B-masterstabilize-quickfix-13421.100.B-masterstabilize-13421.99.B-masterstabilize-13421.96.B-masterstabilize-13421.89.B-masterstabilize-13421.80.B-masterstabilize-13421.73.B-masterstabilize-13421.103.B-masterstabilize-13421.102.B-masterrelease-R86-13421.B-masterBhanu Prakash Maiya2020-10-131-41/+112
* Revert "util: add gen_bmi_config utility"stabilize-13421.53.B-masterstabilize-13421.42.B-masterKeith Short2020-08-214-308/+1
* bmi260: back out support for compressed config fileKeith Short2020-08-212-175/+6
* TCPMv2: SRC->SNK PR Swap enable AutoDischarge after VbusDenis Brockus2020-08-211-15/+37
* TCPMv2: PR_Swap SRC->SNK should send PS_RDY in current AMSDenis Brockus2020-08-211-6/+16
* TCPMv2: Do not send GetSnkCap if FRS is not enabledDenis Brockus2020-08-211-1/+10
* dirinboz: add LED behaviorZick Wei2020-08-203-67/+165
* Zork: Add command to print temps periodicallyEdward Hill2020-08-204-6/+56
* bmi260: move BMI260 init file into .init.rom sectionKeith Short2020-08-205-19/+75
* EC: Fix presubmit message to avoid unbounded parallel makeAndrew McRae2020-08-201-2/+5
* riscv-rv32i: Enable FPU extension only if CONFIG_FPU is enabledDino Li2020-08-201-1/+3
* Dood: set SYV682X HV_ILIM to 5.5AYu-An Chen2020-08-201-0/+3
* Puff: Enable AP reset command handlerAndrew McRae2020-08-201-0/+4
* ampton: increase tasks stackDino Li2020-08-201-3/+3
* BB retimer: Remove FORCE_PWR GPIO from EC driverVijay Hiremath2020-08-1920-40/+59
* usbc: wake task on every state transitionJett Rink2020-08-196-26/+25
* cleanup: update formatting for clarityJett Rink2020-08-191-11/+10
* TCPM common: Store number of Identity VDOsDiana Z2020-08-192-0/+3
* todor: modify gpio for mb/db typec FRS_ENDavid Huang2020-08-191-0/+2
* mt6360: revise vbus presence detection logicTing Shen2020-08-192-12/+29
* pompom: detect lid angle in S3AlvinCC_Hsu2020-08-191-0/+4
* todor: Remove LED_SIDESEL_4_L function and config.David Huang2020-08-194-39/+1
* it83xx/spi: change configuration to IS_ENABLED() styletim2020-08-191-69/+67
* util: uut: add npcx7m7fc to the device-to-flash_size mapping tableCHLin2020-08-191-5/+12
* npcx7_evb: add support for npcx7m7fc to npcx7_evbCHLin2020-08-192-6/+9
* npcx7: introduce new chip variant npcx7m7fcCHLin2020-08-194-10/+23
* burnet: add power ledTommy Chung2020-08-192-13/+41
* intelrvp: Enable apreset host command needed for CSE LiteVijay Hiremath2020-08-191-0/+2
* waddledoo: Configure unused GPIOs as inputsBrian J. Nemec2020-08-191-0/+12
* sm5803: Enable end of charge interrupts for logsAseda Aboagye2020-08-181-0/+15
* common: gyro_cal: Implement gyroscope calibrationYuval Peress2020-08-1811-18/+1904
* Revert "power: Don't boot after waking up from hibernation"Daisuke Nojiri2020-08-181-6/+0
* Revert "system: Clear AP_IDLE when waking up from hibernation by AC"Daisuke Nojiri2020-08-182-15/+2
* TCPMv2: Debounce VBUS on SRC to SNK swapKeith Short2020-08-181-2/+21
* sc7180: Increase the timeout of waiting enough powerWai-Hong Tam2020-08-181-1/+1
* endeavour: add pse host commandJeff Chase2020-08-182-7/+116
* burnet: add IMU sensorsDevin Lu2020-08-183-30/+166
* esche: Add batteries supportDevin Lu2020-08-182-12/+128
* burnet: Add batteries supportDevin Lu2020-08-182-11/+127
* util: ecst: add support for chip variant npcx7m7fcCHLin2020-08-182-114/+77
* voxel: modify motion sensors configBen Chen2020-08-184-30/+29
* cortex-m: Fix flash size calculation boards without flashKeith Short2020-08-181-25/+25
* config: Require battery >5% to enable PD Try.SRCWai-Hong Tam2020-08-183-10/+2
* Dedede: Lower EEPROM i2c speedDiana Z2020-08-171-1/+1
* volteer: Add support for EC_CMD_AP_RESET host commandTim Wawrzynczak2020-08-171-0/+9
* sm5803: Fix linear mode enableAseda Aboagye2020-08-171-2/+3
* Dalboz/Dirinboz: Consolidate retimer power control functionsJosie Nordrum2020-08-172-24/+24
* terrador: modify gpio for mb/db typec FRS_ENDavid Huang2020-08-171-0/+2
* terrador: Remove LED_SIDESEL_4_L function and config.David Huang2020-08-173-36/+1
* test: rename usb_pe_drp to usb_pe_drp_oldPaul Fagerburg2020-08-178-8/+377
View Lorry Controller Status