summaryrefslogtreecommitdiff
Commit message (Expand)AuthorAgeFilesLines
* Clear OWNERS for factory/firmware branchfactory-trogdor-13443.B-masterBrian Norris2021-09-107-21/+0
* flash_fp_mcu: Add delay to consider bootloader startupSujit Kautkar2021-04-281-0/+8
* flash_fp_mcu: Minor spacing fixCraig Hesling2021-02-221-1/+1
* flash_fp_mcu: Add initial support for strongbadCraig Hesling2021-02-221-1/+36
* flash_fp_mcu: Add check for drivers that change nrst and boot0Craig Hesling2021-02-221-1/+15
* flash_fp_mcu: Refactor to use gpio functionCraig Hesling2021-02-221-20/+41
* flash_fp_mcu: Add config for guybrushBhanu Prakash Maiya2021-02-221-0/+16
* flash_fp_mcu: Remove trailing spaceCraig Hesling2021-02-221-1/+1
* flash_fp_mcu: Add comment about zork pwr enable gpioCraig Hesling2021-02-221-1/+2
* flash_fp_mcu: Add config zork, uart transport and gpiosBhanu Prakash Maiya2021-02-221-41/+112
* PCHG: Add host commandDaisuke Nojiri2021-02-012-0/+116
* eve: Move board level TCPC init to happen in pd_task initDuncan Laurie2020-08-314-2/+23
* fpsensor: Run maintenance when in maintenance modeTom Hughes2020-08-315-0/+31
* eve: Check for XCHG|XDSG bits for determining battery presenceScott Collyer2020-08-301-2/+34
* eve: Leave keyboard enabled in magic keyboard mode.Gwendal Grignou2020-08-301-2/+3
* magolor: Reconfig LED GPIO, and modify Led behaviorBen Chen2020-08-304-76/+65
* zork: Enable CONFIG_CHARGE_RAMP_SWEdward Hill2020-08-3010-0/+36
* eve: add motion lid checkGwendal Grignou2020-08-291-0/+2
* meep: enable 2nd TCPC source PS8755 for port 1Marco Chen2020-08-292-0/+21
* Octopus: Initiate the first version of parsing SSFC of CBIMarco Chen2020-08-293-1/+61
* morphius: update GPIO for mst functionZick Wei2020-08-292-3/+6
* pi3usb9201: Switch to SDP while DFP is connectedEdward Hill2020-08-291-7/+35
* morphius: Ignore TABLET_MODE_GPIO_L on boards with version < 3Furquan Shaikh2020-08-292-0/+13
* stm32g4: Fix build issue with i2c driverScott Collyer2020-08-292-2/+1
* zork: Use gpio_or_ioex_set_level for PORT_TO_HPDEdward Hill2020-08-291-2/+2
* zork: Delay between G3 exit and power buttonEdward Hill2020-08-292-0/+21
* power_button: Add CONFIG_POWER_BUTTON_TO_PCH_CUSTOMEdward Hill2020-08-293-1/+16
* driver: add icm426xx chip type defineJean-Baptiste Maneyrol2020-08-292-0/+4
* driver: add ICM-426xx driver supportJean-Baptiste Maneyrol2020-08-297-0/+1729
* sm5803: Configure BFET alertsAseda Aboagye2020-08-292-8/+54
* eve: Check physical battery presence before inhibiting powerDuncan Laurie2020-08-281-0/+1
* ezkinil/woomax: Fix HDMI DATA_EN for OPT3 DBEdward Hill2020-08-282-4/+4
* TCPMv2: Send SOP'/SOP'' VDM only when the port is VCONN srcAyushee2020-08-283-3/+78
* morphius: fix HDMI_DATA_EN_DB on daliZick Wei2020-08-281-2/+3
* TCPMv2: set VDM response buffer and lengthli feng2020-08-282-13/+38
* berknip: fix HDMI_DATA_EN_DB on daliZick Wei2020-08-281-2/+4
* willow: Support new battery AP19B5KDavid Huang2020-08-282-0/+28
* voxel: support TBT/USB4 for C0/C1 portBen Chen2020-08-281-26/+0
* asurada: keep PP5000_A on at G3Ting Shen2020-08-283-4/+6
* jacuzzi: remove ADC_BATT_IDTing Shen2020-08-2818-18/+0
* driver/it83xx, it8xxx2.c: add auto toggle optionRuibin Chang2020-08-282-0/+6
* TCPMv2: handle un- and supported auto toggle TCPCRuibin Chang2020-08-281-0/+14
* halvor: implement LED behaviorSamsp_Liu2020-08-283-84/+68
* driver: bmi160: Read only the first 2 bytes of the interrupt fieldGwendal Grignou2020-08-281-1/+1
* iteflash: Reset EC's GPIOs while flashingDino Li2020-08-281-4/+64
* eve: Cut off critically low batteryDuncan Laurie2020-08-271-0/+1
* it83xx/system: Don't disable DBGR in system resetDino Li2020-08-272-9/+21
* Dedede: Clean up chg_chip referencesDiana Z2020-08-274-10/+8
* Charger: Add chgnum parameter to OTG set functionsDiana Z2020-08-277-20/+29
* OCPC: Assume port == chgnum when checking OTGDiana Z2020-08-271-0/+3
View Lorry Controller Status