1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
|
/*
* board/amlogic/txl_skt_v1/firmware/scp_task/pwr_ctrl.c
*
* Copyright (C) 2015 Amlogic, Inc. All rights reserved.
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License as published by
* the Free Software Foundation; either version 2 of the License, or
* (at your option) any later version.
*
* This program is distributed in the hope that it will be useful, but WITHOUT
* ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or
* FITNESS FOR A PARTICULAR PURPOSE. See the GNU General Public License for
* more details.
*
* You should have received a copy of the GNU General Public License along
* with this program; if not, write to the Free Software Foundation, Inc.,
* 51 Franklin Street, Fifth Floor, Boston, MA 02110-1301, USA.
*/
#include <gpio.h>
#include "pwm_ctrl.h"
#ifdef CONFIG_CEC_WAKEUP
#include <cec_tx_reg.h>
#endif
#define ARRAY_SIZE(x) (sizeof(x) / sizeof((x)[0]))
static void set_vddee_voltage(unsigned int target_voltage)
{
unsigned int to, pwm_size = 0;
static int (*pwm_voltage_ee)[2];
/* BOOT_9 = H use PWM_CFG0(0.67v-0.97v), =L use PWM_CFG1(0.69v-0.89v) */
/*set BOOT_9 input mode*/
writel((readl(PREG_PAD_GPIO0_EN_N) | 0x200), PREG_PAD_GPIO0_EN_N);
if (((readl(PREG_PAD_GPIO0_EN_N) & 0x200 ) == 0x200) &&
((readl(PREG_PAD_GPIO0_I) & 0x200 ) == 0x0)) {
uart_puts("use vddee new table!");
uart_puts("\n");
pwm_voltage_ee = pwm_voltage_table_ee_new;
pwm_size = ARRAY_SIZE(pwm_voltage_table_ee_new);
} else {
uart_puts("use vddee table!");
uart_puts("\n");
pwm_voltage_ee = pwm_voltage_table_ee;
pwm_size = ARRAY_SIZE(pwm_voltage_table_ee);
}
for (to = 0; to < pwm_size; to++) {
if (pwm_voltage_ee[to][1] >= target_voltage) {
break;
}
}
if (to >= pwm_size) {
to = pwm_size - 1;
}
writel(*(*(pwm_voltage_ee + to)), AO_PWM_PWM_B);
}
static void power_off_at_24M(unsigned int suspend_from)
{
/*set gpioH_8 low to power off vcc 5v*/
writel(readl(PREG_PAD_GPIO3_EN_N) & (~(1 << 8)), PREG_PAD_GPIO3_EN_N);
writel(readl(PERIPHS_PIN_MUX_C) & (~(0xf)), PERIPHS_PIN_MUX_C);
/*set test_n low to power off vcck & vcc 3.3v*/
writel(readl(AO_GPIO_O) & (~(1 << 31)), AO_GPIO_O);
writel(readl(AO_GPIO_O_EN_N) & (~(1 << 31)), AO_GPIO_O_EN_N);
writel(readl(AO_RTI_PIN_MUX_REG1) & (~(0xf << 28)), AO_RTI_PIN_MUX_REG1);
/*step down ee voltage*/
set_vddee_voltage(CONFIG_VDDEE_SLEEP_VOLTAGE);
}
static void power_on_at_24M(unsigned int suspend_from)
{
/*step up ee voltage*/
set_vddee_voltage(CONFIG_VDDEE_INIT_VOLTAGE);
/*set test_n low to power on vcck & vcc 3.3v*/
writel(readl(AO_GPIO_O) | (1 << 31), AO_GPIO_O);
writel(readl(AO_GPIO_O_EN_N) & (~(1 << 31)), AO_GPIO_O_EN_N);
writel(readl(AO_RTI_PIN_MUX_REG1) & (~(0xf << 28)), AO_RTI_PIN_MUX_REG1);
_udelay(100);
/*set gpioH_8 low to power on vcc 5v*/
writel(readl(PREG_PAD_GPIO3_EN_N) | (1 << 8), PREG_PAD_GPIO3_EN_N);
writel(readl(PERIPHS_PIN_MUX_C) & (~(0xf)), PERIPHS_PIN_MUX_C);
_udelay(10000);
}
void get_wakeup_source(void *response, unsigned int suspend_from)
{
struct wakeup_info *p = (struct wakeup_info *)response;
struct wakeup_gpio_info *gpio;
unsigned val;
unsigned i = 0;
p->status = RESPONSE_OK;
val = (POWER_KEY_WAKEUP_SRC | AUTO_WAKEUP_SRC | REMOTE_WAKEUP_SRC |
BT_WAKEUP_SRC | ETH_PHY_GPIO_SRC | CECB_WAKEUP_SRC);
p->sources = val;
/* Power Key: AO_GPIO[3]*/
gpio = &(p->gpio_info[i]);
gpio->wakeup_id = POWER_KEY_WAKEUP_SRC;
gpio->gpio_in_idx = GPIOAO_3;
gpio->gpio_in_ao = 1;
gpio->gpio_out_idx = -1;
gpio->gpio_out_ao = -1;
gpio->irq = IRQ_AO_GPIO0_NUM;
gpio->trig_type = GPIO_IRQ_FALLING_EDGE;
p->gpio_info_count = ++i;
/*Eth:GPIOZ_14*/
gpio = &(p->gpio_info[i]);
gpio->wakeup_id = ETH_PHY_GPIO_SRC;
gpio->gpio_in_idx = GPIOZ_14;
gpio->gpio_in_ao = 0;
gpio->gpio_out_idx = -1;
gpio->gpio_out_ao = -1;
gpio->irq = IRQ_GPIO0_NUM;
gpio->trig_type = GPIO_IRQ_FALLING_EDGE;
p->gpio_info_count = ++i;
}
extern void __switch_idle_task(void);
static unsigned int detect_key(unsigned int suspend_from)
{
int exit_reason = 0;
unsigned *irq = (unsigned *)WAKEUP_SRC_IRQ_ADDR_BASE;
backup_remote_register();
init_remote();
#ifdef CONFIG_CEC_WAKEUP
if (hdmi_cec_func_config & 0x1) {
remote_cec_hw_reset();
cec_node_init();
}
#endif
do {
#ifdef CONFIG_CEC_WAKEUP
if (irq[IRQ_AO_CECB] == IRQ_AO_CEC2_NUM) {
irq[IRQ_AO_CECB] = 0xFFFFFFFF;
if (cec_power_on_check())
exit_reason = CEC_WAKEUP;
}
#endif
if (irq[IRQ_AO_IR_DEC] == IRQ_AO_IR_DEC_NUM) {
irq[IRQ_AO_IR_DEC] = 0xFFFFFFFF;
if (remote_detect_key())
exit_reason = REMOTE_WAKEUP;
}
if (irq[IRQ_VRTC] == IRQ_VRTC_NUM) {
irq[IRQ_VRTC] = 0xFFFFFFFF;
exit_reason = RTC_WAKEUP;
}
if (irq[IRQ_AO_GPIO0] == IRQ_AO_GPIO0_NUM) {
irq[IRQ_AO_GPIO0] = 0xFFFFFFFF;
if ((readl(AO_GPIO_I) & (1<<3)) == 0)
exit_reason = POWER_KEY_WAKEUP;
}
if (irq[IRQ_GPIO0] == IRQ_GPIO0_NUM) {
irq[IRQ_GPIO0] = 0xFFFFFFFF;
if (!(readl(PREG_PAD_GPIO4_I) & (0x01 << 14))
&& (readl(PREG_PAD_GPIO4_EN_N) & (0x01 << 14)))
exit_reason = ETH_PHY_GPIO;
}
if (irq[IRQ_ETH_PTM] == IRQ_ETH_PMT_NUM) {
irq[IRQ_ETH_PTM]= 0xFFFFFFFF;
exit_reason = ETH_PMT_WAKEUP;
}
if (exit_reason)
break;
else
__switch_idle_task();
} while (1);
restore_remote_register();
return exit_reason;
}
static void pwr_op_init(struct pwr_op *pwr_op)
{
pwr_op->power_off_at_24M = power_off_at_24M;
pwr_op->power_on_at_24M = power_on_at_24M;
pwr_op->detect_key = detect_key;
pwr_op->get_wakeup_source = get_wakeup_source;
}
|
