1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
|
/* Copyright 2021 The Chromium OS Authors. All rights reserved.
* Use of this source code is governed by a BSD-style license that can be
* found in the LICENSE file.
*/
/* Homestar board configuration */
#ifndef __CROS_EC_BOARD_H
#define __CROS_EC_BOARD_H
#include "baseboard.h"
/* On-body detection */
#define CONFIG_BODY_DETECTION
#define CONFIG_BODY_DETECTION_SENSOR LID_ACCEL
#define CONFIG_BODY_DETECTION_VAR_NOISE_FACTOR 150 /* % */
#define CONFIG_GESTURE_DETECTION
#define CONFIG_GESTURE_DETECTION_MASK BIT(CONFIG_BODY_DETECTION_SENSOR)
#define CONFIG_GESTURE_HOST_DETECTION
/* TODO(waihong): Remove the following bringup features */
#define CONFIG_BRINGUP
#define CONFIG_SYSTEM_UNLOCKED /* Allow dangerous commands. */
#define CONFIG_USB_PD_DEBUG_LEVEL 3
#define CONFIG_CMD_GPIO_EXTENDED
#define CONFIG_CMD_POWERINDEBUG
#define CONFIG_I2C_DEBUG
#define CONFIG_DEVICE_EVENT
#define CONFIG_BUTTON_TRIGGERED_RECOVERY
/* Internal SPI flash on NPCX7 */
#define CONFIG_FLASH_SIZE_BYTES (512 * 1024) /* 512KB internal spi flash */
/* Switchcap */
#define CONFIG_LN9310
/* Battery */
#define CONFIG_BATTERY_DEVICE_CHEMISTRY "LION"
#define CONFIG_BATTERY_REVIVE_DISCONNECT
#define CONFIG_BATTERY_FUEL_GAUGE
#define CONFIG_BATTERY_VENDOR_PARAM
/* Enable PD3.0 */
#define CONFIG_USB_PD_REV30
/* BC 1.2 Charger */
#define CONFIG_BC12_DETECT_PI3USB9201
/* USB */
#define CONFIG_USB_PD_TCPM_MULTI_PS8XXX
#define CONFIG_USB_PD_TCPM_PS8755
#define CONFIG_USB_PD_TCPM_PS8805
#define CONFIG_USBC_PPC_SN5S330
#define CONFIG_USB_PD_PORT_MAX_COUNT 2
/* BMI160 Lid accel/gyro */
#define CONFIG_ACCELGYRO_BMI160
#define CONFIG_ACCEL_INTERRUPTS
#define CONFIG_ACCELGYRO_BMI160_INT_EVENT \
TASK_EVENT_MOTION_SENSOR_INTERRUPT(LID_ACCEL)
#define OPT3001_I2C_ADDR_FLAGS OPT3001_I2C_ADDR1_FLAGS
#define CONFIG_TABLET_MODE
#define CONFIG_TABLET_MODE_SWITCH
#define CONFIG_GMR_TABLET_MODE
#define CONFIG_FRONT_PROXIMITY_SWITCH
#define CONFIG_DETACHABLE_BASE
#define CONFIG_BASE_ATTACHED_SWITCH
/* GPIO alias */
#define GPIO_AC_PRESENT GPIO_CHG_ACOK_OD
#define GPIO_WP_L GPIO_EC_FLASH_WP_ODL
#define GPIO_PMIC_RESIN_L GPIO_PM845_RESIN_L
/* TODO(Dolan): check which pin was used for tablet mode detect */
#define GMR_TABLET_MODE_GPIO_L GPIO_LID_OPEN_EC
#define GPIO_SWITCHCAP_PG_INT_L GPIO_LN9310_INT
#define CONFIG_MKBP_INPUT_DEVICES
#ifndef __ASSEMBLER__
#include "gpio_signal.h"
#include "registers.h"
enum adc_channel {
ADC_VBUS,
ADC_AMON_BMON,
ADC_PSYS,
ADC_BASE_DET,
ADC_CH_COUNT
};
/* Motion sensors */
enum sensor_id {
LID_ACCEL = 0,
LID_GYRO,
SENSOR_COUNT,
};
enum pwm_channel {
PWM_CH_DISPLIGHT = 0,
PWM_CH_COUNT
};
/* List of possible batteries */
enum battery_type {
BATTERY_GH02047XL_1C,
BATTERY_GH02047XL,
BATTERY_DS02032XL,
BATTERY_DS02032XL_1C,
BATTERY_L21D4PG0,
BATTERY_L21M4PG0,
BATTERY_TYPE_COUNT,
};
/* Reset all TCPCs. */
void board_reset_pd_mcu(void);
void board_set_tcpc_power_mode(int port, int mode);
/* Base detection */
void base_detect_interrupt(enum gpio_signal signal);
#endif /* !defined(__ASSEMBLER__) */
#endif /* __CROS_EC_BOARD_H */
|
