| Commit message (Expand) | Author | Age | Files | Lines |
|---|
| * | Merge git://git.denx.de/u-boot-mmc | Tom Rini | 2018-01-24 | 1 | -0/+2 |
| |\ |
|
| | * | configs: odroid-xu3: enable the configs relevant to regulator | Jaehoon Chung | 2018-01-24 | 1 | -0/+2 |
| * | | Convert CONFIG_SOC_DA8XX et al to Kconfig | Adam Ford | 2018-01-22 | 2 | -0/+2 |
| * | | ARM: poplar: Use Kconfig to enable CONFIG_FAT_WRITE | Tuomas Tynkkynen | 2018-01-22 | 1 | -0/+1 |
| * | | fs: Migrate ext4 to Kconfig | Tuomas Tynkkynen | 2018-01-22 | 2 | -0/+2 |
| * | | Convert CONFIG_ROCKCHIP_USB2_PHY to Kconfig | Adam Ford | 2018-01-22 | 13 | -0/+14 |
| * | | Convert CONFIG_OMAP_USB_PHY to Kconfig | Adam Ford | 2018-01-22 | 11 | -0/+11 |
| * | | Convert CONFIG_TWL4030_USB to Kconfig | Adam Ford | 2018-01-22 | 8 | -0/+8 |
| * | | Convert CONFIG_DAVINCI_SPI to Kconfig | Adam Ford | 2018-01-22 | 13 | -0/+13 |
| * | | Convert CONFIG_USB_MUSB_HCD et al to Kconfig | Adam Ford | 2018-01-22 | 11 | -0/+26 |
| * | | Convert CONFIG_USB_MUSB_OMAP2PLUS et al to Kconfig | Adam Ford | 2018-01-22 | 33 | -0/+33 |
| * | | ARM: omap3_logic: Enable SPL_OF_CONTROL and SPL_OF_PLATDATA | Adam Ford | 2018-01-22 | 1 | -0/+3 |
| |/ |
|
| * | Merge git://git.denx.de/u-boot-arc | Tom Rini | 2018-01-19 | 1 | -0/+1 |
| |\ |
|
| | * | ARC: HSDK: Hang on panic | Eugeniy Paltsev | 2018-01-19 | 1 | -0/+1 |
| * | | powerpc: Drop unreferenced CONFIG_* defines | Tuomas Tynkkynen | 2018-01-19 | 1 | -1/+1 |
| * | | configs: stm32: move config flag from defconfig to Kconfig | Patrice Chotard | 2018-01-19 | 3 | -33/+0 |
| * | | serial: stm32: Rename serial_stm32x7.c to serial_stm32.c | Patrice Chotard | 2018-01-19 | 3 | -3/+3 |
| * | | ARM: qemu-arm: Add support for AArch64 | Tuomas Tynkkynen | 2018-01-19 | 2 | -0/+30 |
| * | | rpi_0_w: Add configs consistent with RpI3 | Drew Moseley | 2018-01-19 | 1 | -0/+7 |
| * | | ARM: dts: omap3-beagle{-xm}: Enable DM and devicetree for BeagleBoard | Derald D. Woods | 2018-01-19 | 1 | -0/+5 |
| * | | ARM: dts: am574x-idk: Add initial support | Lokesh Vutla | 2018-01-19 | 2 | -2/+2 |
| |/ |
|
| * | Merge git://git.denx.de/u-boot-fsl-qoriq | Tom Rini | 2018-01-17 | 3 | -0/+64 |
| |\ |
|
| | * | armv8: ls1088: Add USB and PCI configs in SD-BOOT defconfig | Ashish Kumar | 2018-01-17 | 2 | -0/+24 |
| | * | board: ls1012a: LS1012A-2G5RDB board support | Bhaskar Upadhaya | 2018-01-15 | 1 | -0/+40 |
| * | | Merge git://git.denx.de/u-boot-net | Tom Rini | 2018-01-15 | 17 | -16/+35 |
| |\ \ |
|
| | * | | net: sh-eth: Add to Kconfig and convert | Nobuhiro Iwamatsu | 2018-01-15 | 16 | -16/+32 |
| | * | | configs: Update Lamobo_R1 with B53 switch options | Florian Fainelli | 2018-01-15 | 1 | -0/+3 |
| | |/ |
|
| * | | Merge git://git.denx.de/u-boot-imx | Tom Rini | 2018-01-15 | 6 | -3/+88 |
| |\ \ |
|
| | * | | ARM: imx: cm_fx6: env: try to determine dtb to use | Christopher Spinrath | 2018-01-12 | 1 | -1/+1 |
| | * | | imx: mx6ull-14x14-evk: enable DM QSPI driver | Peng Fan | 2018-01-12 | 2 | -0/+12 |
| | * | | imx: mx6sxsabresd: Enable DM driver | Peng Fan | 2018-01-12 | 2 | -0/+24 |
| | * | | ARM: imx: Enable dts for i.MX6SX-SDB | Peng Fan | 2018-01-12 | 2 | -2/+4 |
| | * | | mx6: Support SKS-Kinkel sksimx6 Board | Stefano Babic | 2018-01-12 | 1 | -0/+47 |
| * | | | db410c: use the device tree parsed by the lk loader. | Jorge Ramirez-Ortiz | 2018-01-15 | 1 | -0/+1 |
| * | | | db410c: replace reset driver with psci | Jorge Ramirez-Ortiz | 2018-01-15 | 1 | -1/+1 |
| * | | | db410c: update wlan and bt mac addresses from firmware | Jorge Ramirez-Ortiz | 2018-01-15 | 1 | -0/+3 |
| * | | | db820c: enable pmic gpios for pm8994 | Jorge Ramirez-Ortiz | 2018-01-15 | 1 | -0/+7 |
| * | | | db820c: add qualcomm dragonboard 820C support | Jorge Ramirez-Ortiz | 2018-01-15 | 1 | -0/+36 |
| | |/
|/| |
|
| * | | Merge git://git.denx.de/u-boot-mmc | Tom Rini | 2018-01-14 | 5 | -0/+8 |
| |\ \ |
|
| | * | | am335x_hs_evm: Trim options in SPL to reduce binary size | Tom Rini | 2018-01-12 | 1 | -0/+4 |
| | * | | configs: omapl138_lcdk: decrease the loglevel to reduce the size of the SPL | Jean-Jacques Hiblot | 2018-01-12 | 1 | -0/+1 |
| | * | | configs: openrd: removed support for eMMC hardware partitioning | Jean-Jacques Hiblot | 2018-01-12 | 3 | -0/+3 |
| * | | | riscv: defconfig: Add nx25-ae250 defconfig to support RISC-V | Rick Chen | 2018-01-12 | 1 | -0/+36 |
| | |/
|/| |
|
| * | | Merge git://git.denx.de/u-boot-sunxi | Tom Rini | 2018-01-11 | 2 | -0/+20 |
| |\ \ |
|
| | * | | configs: sun50i: Enable eMMC on a64-olinuxino | Jagan Teki | 2018-01-12 | 1 | -0/+1 |
| | * | | sunxi: Add support for Libre Computer Board ALL-H3-CC H3 ver. | Chen-Yu Tsai | 2018-01-10 | 1 | -0/+19 |
| * | | | Merge git://git.denx.de/u-boot-fsl-qoriq | Tom Rini | 2018-01-11 | 2 | -0/+45 |
| |\ \ \ |
|
| | * | | | ls1088ardb: Add SD Secure boot target support | Sumit Garg | 2018-01-10 | 1 | -0/+44 |
| | * | | | configs: Move SYS_DPAA_QBMAN to Kconfig | Ahmed Mansour | 2018-01-10 | 1 | -0/+1 |
| | | |/
| |/| |
|
| * | | | Merge git://git.denx.de/u-boot-socfpga | Tom Rini | 2018-01-11 | 12 | -0/+12 |
| |\ \ \ |
|
