| Commit message (Expand) | Author | Age | Files | Lines |
|---|
| * | Blackfin: cm-bf537e/cm-bf537u/tcm-bf537: update network settings | Harald Krapfenbauer | 2011-07-12 | 6 | -47/+75 |
| * | Blackfin: sync MMR read/write helpers with Linux | Mike Frysinger | 2011-07-12 | 1 | -46/+42 |
| * | Blackfin: gpio: optimize free path a little | Mike Frysinger | 2011-07-12 | 2 | -1/+4 |
| * | Blackfin: post: setup default CONFIG_SYS_POST_WORD_ADDR | Mike Frysinger | 2011-07-12 | 2 | -1/+3 |
| * | Blackfin: uart: fix printf warning | Mike Frysinger | 2011-07-12 | 1 | -1/+1 |
| * | Blackfin: add init.elf helper code | Mike Frysinger | 2011-07-12 | 5 | -2/+45 |
| * | Blackfin: dont reset SWRST on newer bf526 parts | Mike Frysinger | 2011-07-12 | 1 | -1/+3 |
| * | Blackfin: adi boards: enable multi serial support by default | Mike Frysinger | 2011-07-12 | 1 | -0/+4 |
| * | Blackfin: uart: add multiple serial support | Mike Frysinger | 2011-07-12 | 6 | -55/+222 |
| * | Blackfin: uart: move debug buffers into local bss | Mike Frysinger | 2011-07-12 | 1 | -8/+3 |
| * | powerpc/85xx: Add default usb mode and phy type to hwconfig | Ramneek Mehresh | 2011-07-11 | 4 | -4/+13 |
| * | powerpc/corenet_ds: add back buffer write for NOR flash | York Sun | 2011-07-11 | 1 | -0/+1 |
| * | powerpc/85xx: remove SERDES4 soft-reset work-around | Timur Tabi | 2011-07-11 | 1 | -22/+49 |
| * | powerpc/mpc8xxx: Allow override DDR read-to-write turnaround time | York Sun | 2011-07-11 | 2 | -0/+6 |
| * | qoriq/p1_p2_rdb: USB device-tree fixups for P1020 | Ramneek Mehresh | 2011-07-11 | 1 | -0/+47 |
| * | powerpc/85xx: Specify hwconfig usage for USB controller | Ramneek Mehresh | 2011-07-11 | 1 | -0/+25 |
| * | powerpc/8xxx: Update USB mode device tree fixup | Ramneek Mehresh | 2011-07-11 | 1 | -12/+65 |
| * | powerpc/85xx: Add basic support for P1023RDS board | Roy Zang | 2011-07-11 | 11 | -0/+1303 |
| * | powerpc/mpc85xx: Display a warning for unsupported DDR data rates | York Sun | 2011-07-11 | 5 | -4/+27 |
| * | powerpc/corenet_ds: Fix RCW overriding for RDIMM | York Sun | 2011-07-11 | 1 | -1/+1 |
| * | powerpc/mpc8xxx: fix DDR data width checking | York Sun | 2011-07-11 | 1 | -8/+27 |
| * | powerpc/mpc8xxx: Adding fallback to raw timing on supported boards | York Sun | 2011-07-11 | 1 | -0/+8 |
| * | powerpc/mpc8xxx: Enable calculation for fixed DDR chips | York Sun | 2011-07-11 | 5 | -3/+39 |
| * | powerpc/85xx: Fix pin muxing for second USB controller | Felix Radensky | 2011-07-11 | 1 | -1/+1 |
| * | Adding more SPD registers | York Sun | 2011-07-11 | 1 | -1/+3 |
| * | powerpc/mpc8xxx: Add 16-bit support for DDR3 | York Sun | 2011-07-11 | 3 | -2/+18 |
| * | powerpc/mpc8xxx: check SPD length before using part number | York Sun | 2011-07-11 | 1 | -1/+2 |
| * | powerpc/mpc8xxx: adjust DDR burst length and chop accroding to sdram width | York Sun | 2011-07-11 | 1 | -4/+20 |
| * | powerpc/86xx: display boot device and bank on the MPC8610 HPCD | Timur Tabi | 2011-07-11 | 1 | -2/+23 |
| * | powerpc/85xx: Add NAND boot support for P3041/P5020DS | Shaohui Xie | 2011-07-11 | 2 | -6/+25 |
| * | powerpc/85xx: Add P2041 processor support | Kumar Gala | 2011-07-11 | 5 | -0/+26 |
| * | powerpc/p2040: Add various p2040 specific information | Mingkai Hu | 2011-07-11 | 3 | -0/+133 |
| * | powerpc/85xx: Fix compile errors if CONFIG_SYS_DPAA_QBMAN isn't set | Kumar Gala | 2011-07-11 | 4 | -13/+24 |
| * | qoriq/p1_p2_rdb: Add Dual Role USB support macro for P1020RDB | Ramneek Mehresh | 2011-07-11 | 1 | -0/+1 |
| * | powerpc/85xx: Fix compile errors if CONFIG_SYS_{BR,OR}0_PRELIM aren't set | Kumar Gala | 2011-07-11 | 1 | -0/+2 |
| * | powerpc/85xx: Fix compile errors if CONFIG_SYS_{B,Q}MAN_MEM_PHYS aren't set | Kumar Gala | 2011-07-11 | 2 | -0/+8 |
| * | MPC83XX: Fix PCI express clock setup | Bill Cook | 2011-07-06 | 1 | -2/+4 |
| * | powerpc/83xx: remove empty board_early_init_f() | Timur Tabi | 2011-07-06 | 4 | -13/+0 |
| * | mpc83xx: Add support for MergerBox board | Andre Schwarz | 2011-07-06 | 11 | -0/+1504 |
| * | MPC83xx: add config options for memory setup. | Andre Schwarz | 2011-07-06 | 1 | -1/+18 |
| * | MPC83xx: add define for global half-strength enable (HSE) | Andre Schwarz | 2011-07-06 | 1 | -0/+1 |
| * | MPC837x: set i2c1_clk | Andre Schwarz | 2011-07-06 | 1 | -0/+2 |
| * | fsl_dma: fix support for 83xx DMA engine | Ira W. Snyder | 2011-07-06 | 1 | -0/+2 |
| * | Add support for Network Space v2 and parents | Simon Guinot | 2011-07-04 | 7 | -0/+566 |
| * | arm/km: add support for portl2 board | Valentin Longchamp | 2011-07-04 | 5 | -3/+89 |
| * | arm/km: replace suenx targets with km_kirkwood | Holger Brunck | 2011-07-04 | 6 | -60/+25 |
| * | arm/km: ethernet support for mgcoge3un | Valentin Longchamp | 2011-07-04 | 1 | -1/+38 |
| * | arm/km: use board KM_ENV_BUS for CONFIG_I2C_ENV_EEPROM_BUS | Valentin Longchamp | 2011-07-04 | 1 | -1/+1 |
| * | arm/km: remove unneeded define | Holger Brunck | 2011-07-04 | 1 | -2/+0 |
| * | arm/km: fix u-boot.kwb build breakage | Holger Brunck | 2011-07-04 | 2 | -22/+7 |
