diff options
Diffstat (limited to 'drivers/serial/Kconfig')
| -rw-r--r-- | drivers/serial/Kconfig | 46 |
1 files changed, 46 insertions, 0 deletions
diff --git a/drivers/serial/Kconfig b/drivers/serial/Kconfig index c94353ba6a..6313258eac 100644 --- a/drivers/serial/Kconfig +++ b/drivers/serial/Kconfig @@ -7,6 +7,52 @@ config DM_SERIAL implements serial_putc() etc. The uclass interface is defined in include/serial.h. +config DEBUG_UART + bool "Enable an early debug UART for debugging" + help + The debug UART is intended for use very early in U-Boot to debug + problems when an ICE or other debug mechanism is not available. + + To use it you should: + - Make sure your UART supports this interface + - Enable CONFIG_DEBUG_UART + - Enable the CONFIG for your UART to tell it to provide this interface + (e.g. CONFIG_DEBUG_UART_NS16550) + - Define the required settings as needed (see below) + - Call debug_uart_init() before use + - Call debug_uart_putc() to output a character + + Depending on your platform it may be possible to use this UART before + a stack is available. + + If your UART does not support this interface you can probably add + support quite easily. Remember that you cannot use driver model and + it is preferred to use no stack. + + You must not use this UART once driver model is working and the + serial drivers are up and running (done in serial_init()). Otherwise + the drivers may conflict and you will get strange output. + +config DEBUG_UART_BASE + hex "Base address of UART" + depends on DEBUG_UART + help + This is the base address of your UART for memory-mapped UARTs. + + A default should be provided by your board, but if not you will need + to use the correct value here. + +config DEBUG_UART_CLOCK + int "UART input clock" + depends on DEBUG_UART + help + The UART input clock determines the speed of the internal UART + circuitry. The baud rate is derived from this by dividing the input + clock down. + + A default should be provided by your board, but if not you will need + to use the correct value here. + config UNIPHIER_SERIAL bool "UniPhier on-chip UART support" depends on ARCH_UNIPHIER && DM_SERIAL |