diff options
Diffstat (limited to 'doc')
| -rw-r--r-- | doc/README.mx28_common | 9 |
1 files changed, 5 insertions, 4 deletions
diff --git a/doc/README.mx28_common b/doc/README.mx28_common index 448d221162..8bacaf8a5e 100644 --- a/doc/README.mx28_common +++ b/doc/README.mx28_common @@ -19,6 +19,7 @@ Contents 1) Prerequisites 2) Compiling U-Boot for a MX28 based board 3) Installation of U-Boot for a MX28 based board to SD card +4) Installation of U-Boot into NAND flash 1) Prerequisites ---------------- @@ -29,14 +30,14 @@ is the "mxsboot" tool found in U-Boot source tree. Firstly, obtain the elftosb archive from the following location: - http://foss.doredevelopment.dk/mirrors/imx/elftosb-10.12.01.tar.gz + ftp://ftp.denx.de/pub/tools/elftosb-10.12.01.tar.gz We use a $VER variable here to denote the current version. At the time of writing of this document, that is "10.12.01". To obtain the file from command line, use: $ VER="10.12.01" - $ wget http://foss.doredevelopment.dk/mirrors/imx/elftosb-${VER}.tar.gz + $ wget ftp://ftp.denx.de/pub/tools/elftosb-${VER}.tar.gz Extract the file: @@ -146,8 +147,8 @@ NOTE: If the user needs to adjust the start sector, the "mxsboot" tool contains a "-p" switch for that purpose. The "-p" switch takes the sector number as an argument. -4) Installation of U-Boot for NAND flash ------------------------------------------------ +4) Installation of U-Boot into NAND flash +----------------------------------------- To boot a MX28 based board from NAND, set the boot mode DIP switches according to i.MX28 manual chapter 12.2.1 (Table 12-2), PORT=GPMI, NAND 1.8 V. |